The mobile phone signal amplifier is a product specially designed to solve the poor signal of the mobile phone. Many small partners will worry about how to install the signal amplifier and whether it is troublesome.
Today, Linbao will tell you the installation method and precautions here. In fact, the installation method of the mobile phone signal amplifier is very simple, and it can be easily completed with just a few steps.
How to install a mobile phone signal amplifier?
1. After receiving the goods, first check whether the courier is damaged and whether the items are complete. A normal set of mobile phone signal amplifier consists of host, outdoor antenna, indoor antenna, feeder, power line and so on.
2. Find an outdoor location with relatively good signal to install the outdoor antenna, and connect the other end of the outdoor antenna feeder to the BTS port of the signal amplifier host.
3. Install the indoor antenna at a high place in the room, and connect the other end of the indoor antenna to the MS port of the host.
4. Connect the power cord to the power socket of the mobile phone signal amplifier host, and turn on the power.
Installation Precautions
1. After all accessories are installed, power on and test to avoid the host burn-in.
2. The feeder interface is wrapped with waterproof tape, and the service life will be longer.
3. Do not install the indoor antenna and the outdoor antenna inversely, and the interfaces of the indoor MS and the outdoor BTS cannot be reversed, otherwise there will be no effect.
4. The distance between the host and the outdoor antenna should be as far away as possible, preferably more than 10 meters, or a wall between them. Too close may amplify the signal twice, causing "self-excitation" and affecting the use of the mobile phone signal amplifier.